Lloyd Zusman writes:

> Sam Varshavchik <mrsam@cour...> writes:
>
>> Lloyd Zusman writes:
>>
>>> In using webadmin under the latest version of Courier, it is impossible
>>> to completely turn off hard bounces in the "Bounces" section of the
>>> "Sender Policy Framework" page?  If I uncheck all the boxes in that
>>> section and then click on "Save", the '"Softfail" is a hard bounce'
>>> and '"Fail" is a hard bounce' come back as being checked.  If I turn
>>> them all off except '"Fail" is a hard bounce', then that setting remains.
>>> What do I have to do in order to completely disable bounces, even in
>>> the case of SPF "Fail" results?  I want to do additional processing in
>>> my courierfilters before rejecting these messages.
>>
>> Put:
>>
>> opt BOFHSPFHELO=all
>> opt BOFHSPFMAILFROM=all
>> opt BOFHSPFFROM=all
>>
>> into the bofh file.
>
> Thanks.  I already have the following in bofh (it was set up this way by
> webadmin, based on my settings there).  Do these three lines cause
> Courier to behave differently from the three lines above?
>
>   opt BOFHSPFHELO=pass,fail,none,neutral,softfail,error,unknown
>   opt BOFHSPFMAILFROM=pass,fail,none,neutral,softfail,error,unknown
>   opt BOFHSPFFROM=pass,mailfromok,fail,none,neutral,softfail,error,unknown

Should be the same thing.

>
> Webadmin also set these two lines in bofh.  Should I alter or get rid of
> one or both of these?
>
>   opt BOFHSPFHARDERROR=fail
>   opt BOFHSPFTRUSTME=1
>
> Thanks again.

You should get rid of them, but they don't make any difference.