I had a similar issue once, quite a while ago, I believe with R65. Never
found an answer and had a case opened with Check Point support for months
with no resolution.

At the end, the customer needed to change hardware and I did a clean
install, so the issue went away with the old box.

Regards

On Fri, May 18, 2012 at 8:38 AM, Liu, Huiqi <Huiqi.Liu@cggv...>wrote:

> Hello All,
>
> I have a problem with connecting to our enforcement with WebUI.  It seems
> to have started since I did some internal network changes, and re-IPed one
> of the interfaces, though it could have been there earlier.
>
> IE just says "Internet Explorer cannot display the webpage", ssh access to
> the box is fine.
>
> Rule base looks OK as I can see the traffic being accepted, and httpd is
> running.
>
> Have anyone seen similar problems?
>
> Many thanks!
>
> Huiqi Liu
>
> =================================================
> To set vacation, Out-Of-Office, or away messages,
> send an email to LISTSERV@amad...
> in the BODY of the email add:
> set fw-1-mailinglist nomail
> =================================================
> To unsubscribe from this mailing list,
> please see the instructions at
> http://www.checkpoint.com/services/mailing.html
> =================================================
> If you have any questions on how to change your
> subscription options, email
> fw-1-owner@ts.c...
> =================================================
>



--
Sergio Alvarez
CISSP | CCSE+

=================================================
To set vacation, Out-Of-Office, or away messages,
send an email to LISTSERV@amad...
in the BODY of the email add:
set fw-1-mailinglist nomail
=================================================
To unsubscribe from this mailing list,
please see the instructions at
http://www.checkpoint.com/services/mailing.html
=================================================
If you have any questions on how to change your
subscription options, email
fw-1-owner@ts.c...
=================================================