Hi,

is there a possibility to control "cmsCreateInkLimitingDeviceLink" in  
sense of GCR or UCR?
Is the actual generation GCR or UCR?
I couldn't find anything.

If an ICC input profile is GCR or UCR and as next the ink limit  
device link follows in the transformation chain, what does the actual  
ink limiting change about this after conversion? Will the character  
of the conversion still be likely GCR or UCR, as the input profile is  
designed?


Regards for help,
Wolfgang



--
Pjannto Software e.K.
Steinburger Straße 38
22527 Hamburg, Germany, European Union

Tel.: +49.40. 38 03 89 - 36
E-Mail: wolle.huss@pjan...
Internet: http://www.pjannto.com

AG Hamburg HRA 89770
Steuernummer: 02/125/02502; USt.-IdNr.: DE201961374


Unsere Angebote sind grundsätzlich frei bleibend.
Unsere Preise verstehen sich zzgl. gesetzlicher USt..

**** DISCLAIMER ****
"This e-mail and any attachments thereto may contain information
which is confidential and/or protected by intellectual property
rights and are intended for the sole use of the recipient(s) named  
above.
Any use of the information contained herein (including, but not  
limited to,
total or partial reproduction, communication or distribution in any  
form)
by persons other than the designated recipient(s) is prohibited.
If you have received this e-mail in error, please notify the sender  
either
by telephone or by e-mail and delete the material from any computer.
Thank you for your cooperation."